Harman Stove Company P35I Benutzerhandbuch

28

Pellets or Corn/Pellet Mixture Only                                           3-90-775                                                                           Save These Instructions

3-Blinks; Poor ESP signal.

Broken probe, wire or connection.

Exhaust temperature has gone out of range 

multiple times.

Check connection / Replace Probe

Clean exhaust- possible soot or creosote 

accumulation near probe.

4-Blinks; Poor Room Sensor    

               signal.

Broken sensor, wire or connection.

Check connection / Replace sensor

5-Blinks; Failed ignition

No fuel in hopper

Door, hopper lid, or ash pan open

Poor draft / weak combustion blower

Fuel feed restriction

Blocked airflow / Igniter failure

Load fuel

Close all doors and check seals

Perform draft test, clean exhaust, replace blower if 

necessary.

Check operation in "Test" mode. Clear obstruction

Open burn pot cleanout to access igniter- clean. 

Check igniter, replace if necessary

6-Blinks; Poor combustion

No fuel in hopper

Door, hopper lid, or ash pan open

Poor draft / weak combustion blower

Fuel feed restriction

Load fuel

Close all doors and check seals

Perform draft test, clean exhaust, replace blower if 

necessary.

Check operation in "Test" mode. Clear obstruction

Low volume or no fuel feed

No fuel in hopper

Door, hopper lid, or ash pan open

Poor draft / weak combustion blower

Fuel feed restriction

Failed feed motor

Load fuel

Close all doors and check seals

Perform draft test, clean exhaust, replace blower if 

necessary.

Check operation in "Test" mode. Clear obstruction

Replace motor if necessary

No Distribution Blower 

Fire isn't hot enough for blower operation

MANUAL / STOVE TEMP 

Failed motor or connections- "Test" mode

Increase temperature setting

When operating in manual ignite / stove temp mode, 

the blower will not run below a #3 setting on the 

temperature dial. Increase temperature setting.

Check connections / Replace blower

Low heat output, or room tem-

perature doesn't match ther-

mometer or other readings

Feed rate too low

Room sensor location different than ther-

mometer location 

Excessive ash buildup on heat exchanger 

or in the exhaust

Set feed adjuster at #4 or higher

Room sensor reports the room air temperature to 

the circuit board. Move sensor location or adjust set 

point accordingly

Clean exhaust, firebox, and heat exchanger thor-

oughly.

With proper installation, operation, and maintenance, your appliance will provide years of 

trouble-free service. If you do experience a problem, this troubleshooting guide will assist a 

qualified service person in proper diagnosis and repair. This guide is intended for qualified 

service technician use only.