Windsor SC20 Benutzerhandbuch

SABER (SC)   86038350   01/29/07 

 

 
The front squeegee blade allows solution to pass 
through channels in the blade into the squeegee 
assembly while maintaining vacuum to provide lift.  
 
The rear blade wipes the floor to a near dry 
condition.  It is important the rear blade be in good 
condition to properly do its job.  
 
Check both the front and rear squeegee blades for 
damage and wear each day in the pre-run check.  
Change the front blade if it is torn or has an uneven 
edge.  Change the rear blade if it is less than 1/2 the 
original thickness.   
 

 
1.  With the squeegee in the up position, turn the 

machine power off. 

2.  Loosen both squeegee knobs and pull squeegee 

assembly rearward from the lifting carrier. 

3.  Inspect or repair as necessary and reinstall.

 
1.  With the squeegee in the up position, turn the 

machine power off. 

 
FOR SAFETY: Before leaving or servicing 
machine; stop on level surface, turn off machine 
and remove key. 
 
2.  Remove the squeegee assembly from the 

machine.  Remove all screws and remove blade 
retainer strap and remove squeegee blade. 

3.  Replace squeegee blades as required. 
4.  Install blade with ribbed surface facing out. 
5.  Install squeegee retainer strap. 
6.  Install all screws starting from center and 

working to ends. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

 
The front squeegee blade allows solution to pass 
through channels in the blade into the squeegee 
assembly while maintaining vacuum to provide lift.  
The front blade has four wear surfaces and can be 
rotated for extended life.  The front blade should not 
require regular replacement under normal use.   
 
The rear blade wipes the floor to a near dry 
condition.  It is important the rear blade be in good 
condition to properly do its job.  Each rear squeegee 
blade has four wear surfaces for extended service. 
 
Check both the front and rear squeegee blades for 
damage, wear, and adjustment each day in the pre-
run check.  Change the front blade if it is torn or has 
an uneven edge.  Change the rear blade if it is less 
than 1/2 the original thickness. 
 

 
Adjusting the squeegee is a two-part process.  First, 
the squeegee assembly must have correct pitch in 
order for the squeegee blade to have the same 
deflection at each tip as well as the center.  The 
knob on the squeegee linkage controls the pitch 
adjustment.  The second adjustment is the 
deflection.