Cub Cadet 930 SWE Benutzerhandbuch

NOTE: All references 
in this manual to the 
left or right side of the 
snow thrower is from 
the operating position 
only. Exceptions, if any, 
will be specified.

This unit is shipped 
with the engine full of 
oil. After assembly, 
refer to the Tecumseh 
Engines manual 
packed separately with 
your snow thrower 
for fuel and oil fill-up 
details.

IMPORTANT: Two replacement auger shear pins are 
included with this manual (or stowed in the plastic handle 
panel). Refer to the Maintenance section for more 
information regarding shear pin replacement.

NOTE: All references in this manual to the left or right 
side of the snow thrower is from the operating position 
only. Exceptions, if any, will be specified.

IMPORTANT: This unit is shipped with the engine full of 
oil. After assembly, refer to the Tecumseh Engine manual 
packed separately with your snow thrower for fuel and oil 
fill-up details.

NOTE: Specifications are subject to change without 
notification or obligation. Images may not reflect your 
exact model and are for reference purposes only.

1.  Observe the lower area of the snow thrower to be 

sure both cables are aligned with roller guides before 
pivoting handle upward. 
a.  Remove the lower star knob and carriage bolt from 

each side of the lower handle. Pull up and back on 
upper handle as shown in Figure 3-1. Align upper 
handle with the lower handle. Make certain the 
springs at the lower end of the auger and drive 
cables are securely hooked into their respective 
actuator bracket.

2.  a. Secure the upper handle and lower handle with the 

two star knobs and carriage bolts removed earlier. 
See Figure 3-2. 

  b. Tighten the two star knobs already installed in the 

upper holes to firmly secure the upper handle and 
support tubes.

Specifications are 
subject to change 
without notification 
or obligation. Images 
may not reflect your 
exact model and are for 
reference purposes only.