Cub Cadet 930 SWE Benutzerhandbuch

Prior to operating 
your snow thrower, 
refer to Auger Control 
Test in the Operation 
section. Read and 
follow all instructions 
carefully and perform 
all adjustments to verify 
your snow thrower is 
operating safely and 
properly.

3.  a. Remove the flat washer and hairpin clip from the 

end of the chute directional control. See Figure 3-3.

b.  Insert the end of the chute directional control 

into the chute bracket and secure with the flat 
washer and hairpin clip just removed. If necessary, 
the chute bracket can be adjusted. Refer to the 
Adjustments section.

IMPORTANT: Prior to operating your snow thrower, 
refer to Auger Control Test in the Operation section. 
Read and follow all instructions carefully and perform 
all adjustments to verify your snow thrower is operating 
safely and properly.

4.  Remove lock nuts and screws securing one of the 

flange keepers to the chute assembly. 

5.  Place chute assembly onto chute base as shown in 

Figure 3-4, making sure that the notches engage with 
the spiral end of chute directional control.

6.  Secure flange keeper removed earlier with lock nuts 

and screws. Tighten down nuts securing the other two 
flange keepers. See Figure 3-5.

7.  Check that all cables are properly routed through the 

cable guide on top of engine shroud. See Figure 3-6.

The extension cord is fastened with a cable tie to the rear 
of the auger housing for shipping purposes. Cut the cable 
tie and remove it before operating the snow thrower.

Holes are located in the plastic dash panel for convenient 
shear pin storage. See Figure 3-7.

Specifications are 
subject to change 
without notification 
or obligation. Images 
may not reflect your 
exact model and are for 
reference purposes only.