Cub Cadet 930 SWE Benutzerhandbuch

Make these final assembly adjustments 

before 

operating your snow thrower for the first time. Failure 
to follow these instructions may cause damage to the 
snow thrower.

Refer to Figure 3-8 for location of controls.
1.  Move the shift lever into sixth (6) position.
2.  With the wheel drive control released, push the 

snow thrower forward, then pull it back. The machine 
should move freely. 

3.  Engage the drive control and attempt to move the 

machine both forward and back, resistance should 
be felt.

4.  Move the shift lever into the fast reverse (R2) 

position and repeat the previous two steps. 

If you experienced resistance rolling the unit, either 
when repositioning the shift lever from 6 to R2 or when 
attempting to move the machine with the drive control 
released, adjust the drive control immediately. See 
Adjusting Drive and Auger Controls.

When the auger control is released and in the disengaged 
“up” position, the cable should have very little slack, but 
should NOT be tight.
1.  In a well-ventilated area, start the snow thrower 

engine as instructed in the Operation section. Make 
sure the throttle is set in the fast position.

2.  While standing in the operator’s position (behind the 

snow thrower), engage the auger control and allow 
the auger to remain engaged for approximately ten 
seconds before releasing the auger control. Repeat 
this several times.

3.  With the engine running in the fast position and the 

auger control in the disengaged “up” position, walk to 
the front of the machine.

  Confirm that the auger has completely stopped 

rotating and shows no signs of motion. 

4.  If the auger shows any signs of rotating, immediately 

return to the operator’s position and shut off the 
engine. Wait for all moving parts to stop before 
readjusting the auger control cable. 

Drive 

Control

Drive 

Control 

Cable

Auger

 

Control

Auger

 

Control 

Cable

Shift Lever

Chute Tilt Control