B.C. Rich Zombie Exotic Classic Benutzerhandbuch

Step 1:

To put on the new string simply slide 

one of the bullets into the nut, then 

place the other bullet into the 

appropriate saddle and push down on 

the back on the saddle until you hear, 

or feel, a snap. 

Step 2:

This sound is the spring-loaded sliding 

latch snapping into place. If you don't 

hear or feel the snap, push the sliding 

latch toward the saddle until it catches. 

Making sure the sliding latch is all the 

way forward to its locked position is 

important because if it isn't two things 

will happen:

1) The replaced string will be held 

sharp, and;

2) the safety catch will not be engaged 

and the string could suddenly and 

unexpectedly be released and fly across 

the room.

Step 4:

Then do a couple of stretching pulls 

on the string.

Step 5:

The string is now seated and no more 

stretching is necessary, just play. In fact 

if you stretch the string too vigorously 

you will damage the string. Just play 

the string in for a bit and re-adjust your 

tuning with the fine-tuning screw as 

needed.

If the string you're replacing was tuned 

to your desired pitch, the new string 

you install should be able to be tuned 

to that pitch with the fine tuner screw. 

If the fine tuners do not have enough 

range to tune the new string to the 

previous pitch you will need to adjust 

the range tuner setscrew as described 

below. See "Setting the fine tuner range 

on the SpeedLoader Tremolo".

Step 3:

Now that the new string has been properly installed you should seat the new 

string. To seat the new string press down firmly on the string just in front of 

the saddle and just in front of the nut.

8

9