Acu-Rite CNC 3500i Benutzerhandbuch
140
7 Programming: Canned Cycles, sub-programs
7.
1 Explaining Basic Cy
cles
Temporary Path Tolerance
The PathTol command is used to temporarily override the parameter
for path tolerance. This should only be used in a program and should
be programmed by itself. The value in the system configuration is
restored at the end of the program. The typical default is 0.010 mm
(0.0004"). This can be useful if the 3500i hesitates between small
moves, such as with a 3-D surface output from CAD-CAM. The feed
rate for corners and curvatures is limited so that error does not exceed
this value.
for path tolerance. This should only be used in a program and should
be programmed by itself. The value in the system configuration is
restored at the end of the program. The typical default is 0.010 mm
(0.0004"). This can be useful if the 3500i hesitates between small
moves, such as with a 3-D surface output from CAD-CAM. The feed
rate for corners and curvatures is limited so that error does not exceed
this value.
Select the More Milling button, and then "PathTol"
from the pop-up menu.
Conversational format: PathTol
G-code format: G1000
Field
Code
Description
PathTol
X
The path tolerance for contour transitions.
The MM range is from 0.0001 to 10.
(Required)
The MM range is from 0.0001 to 10.
(Required)