Enterasys Networks RBTSA-AB Benutzerhandbuch

C

HAPTER

 3: C

ONFIGURING

 

THE

E

THERNET

 A

DAPTER

Under System Configuration, click IP Network. The IP Network Properties 
page appears, where you can change the settings shown in Table 10.

If you change the IP address and click Apply, you cannot continue to 
configure the device using the old IP address. Therefore, you must do the 
following steps after changing the IP address:

1 Close your browser.

2 Return to the Enterasys Networks Wireless Infrastructure Device Manager 

and click Refresh.

3 Select the device and click Configure to start a new configuration session.

Table 10 describes the IP Network properties.

Web GUI 
Protocol

This setting allows users to enable the 
secure data exchange scheme over SSL 
during a configuration session.

■

HTTPS — enables SSL technology.

■

HTTP — disables SSL technology.

HTTP

Table 9   System Properties Page  (continued)

Table 10   IP Network Properties Page

IP Network Setting

This setting allows you to change the IP address of the device.

To let the device get an IP address automatically from a DHCP 
server, select Obtain an IP address automatically and click 
Apply.

To specify an IP address, select Specify an IP address, enter the 
IP address parameters in the spaces provided, and click Apply.

IP Address

When Specify an IP address is selected, enter the IP address in 
the space provided, and click Apply.

Subnet Mask

When Specify an IP address is selected, enter the Subnet Mask 
in the space provided, and click Apply.

Gateway IP 
Address

When Specify an IP address is selected, enter the Gateway IP 
Address in the space provided, and click Apply.