Enterasys Networks 9033900-04 Benutzerhandbuch
Command Groups
A-106
Interface Commands
are used to configure connection parameters for the
Ethernet port and wireless interface.
Table A-15
Interface Commands (Ethernet and Wireless)
Command
Function
Mode
Page
General Interface
interface
Enters specified interface configuration
mode
mode
GC
Ethernet Interface
cdp authentication
Specifies an authentication key for CDP
packets
packets
IC-E
cdp auto-enable
Set CDP in auto-enable mode
GC
cdp disable
Set CDP in disable mode
GC
cdp enable
Set CDP in enable mode
GC
cdp hold-time
Sets amount of time that AP holds
neighbor entry
neighbor entry
GC
cdp tx-frequency
Set CDP transmit frequency
GC
show cdp
Displays CDP global settings, neighbor
entries, traffic statistics or port.
entries, traffic statistics or port.
Exec
dns
Specifies the primary or secondary name
server
server
IC-E
ip address
Sets the IP address for the Ethernet
interface
interface
IC-E
ip dhcp
Submits a DHCP request for an IP
address
address
IC-E
shutdown
Disables the Ethernet interface
IC-E
show interface
ethernet
Shows the status for the Ethernet
interface
interface
Exec
Wireless Interface
description
Adds a description to the wireless
interface
interface
IC-W
IC-W: VAP
IC-W: VAP
secure-access
When enabled, the Access Point denies
access to wireless clients that do not use
the correct wireless network name.
access to wireless clients that do not use
the correct wireless network name.
IC-W
IC-W: VAP
IC-W: VAP
speed
Configures the maximum data rate at
which a station can connect to the
access point
which a station can connect to the
access point
IC-W
channel
Configures the radio channel
IC-W
turbo
Configures turbo mode to use a faster
data rate
data rate
IC-W