ATTO Technology 1550D Benutzerhandbuch

15

 

ATTO Technology Inc. iPBridge Installation and Operation Manual

You may set up the iPBridge to send notifications 
when certain events occur using the Remote 
Management page of the ExpressNAV 
interface.
You designate the person receiving notification of 
conditions and the level of severity which prompt 
notification using the Simple Network 
Management Protocol (SNMP).

For both methods, the severity level which is 
report can be critical, warning or all. 

•  Critical means only critical event notifications 

are sent. 

•  Warning means only warnings and critical event 

notifications are sent. 

•  All means warnings, critical events and 

informational messages are sent.

An agent resides in the iPBridge which takes 
information from the iPBridge and translates it 
into a form compatible with SNMP. If certain 
conditions arise, the agent sends notifications 
(traps) to a client.
Contact your network administrator for the MIB 
software and appropriate MIB file for your 
iPBridge. 

1 Follow 

2 Click 

on 

Remote Mgt from the side menu. The 

Remote Management page appears.

3 In 

the 

SNMP line, click on the enabled button.

4 In 

the 

SNMP Traps or SNMP Extended Traps 

line, click on Enable. For details, refer to 

5 In 

the 

SNMP Trap Recipient IP addresses 

section, enter the IP address of each person you 
want to notify.

6  From the drop-down box next to each trap 

address, select the level of severity for which 
you want each address to be notified: None, All, 
Critical or Warning. 

7 Click 

on 

8  Go to the Restart page and restart the iPBridge. 

After rebooting, the iPBridge sends notifications 
as you set them up.