ATTO Technology 1550D Benutzerhandbuch
vi
Alphabetical CLI command explanations
AccessControl
Controls access on a target node. Access to the target
node is keyed to the iSCSI qualified name of listed
initiators.
Controls access on a target node. Access to the target
node is keyed to the iSCSI qualified name of listed
initiators.
Note
AccessControl cannot be used with iSNS.
Default: disabled on the default node; enabled on all other
nodes
set AccessControl [default | Target Name] [enabled |
disabled]
get AccessControl [default | Target Name]
AccessEntry
Allows the addition or deletion of an initiator entry from
the access control list of a target node. The initiator name
must be formatted as an iSCSI qualified name and must
be between 1 to 223 characters, is case sensitive and
cannot be all.
Allows the addition or deletion of an initiator entry from
the access control list of a target node. The initiator name
must be formatted as an iSCSI qualified name and must
be between 1 to 223 characters, is case sensitive and
cannot be all.
Default: default all
set AccessEntry [default | Target Name | discovery]
set AccessEntry [default | Target Name | discovery]
[Initiator Name <delete> | all [delete]]
get AccessEntry [default | Target Name | discovery]
AutoMap
Automatically maps all target devices visible to the
iPBridge to iSCSI addresses. If you use no arguments, all
devices are mapped to the default target. If you specify a
target, all devices are mapped to that target. If you
specify *, each device is mapped to its own auto-named
target.
Automatically maps all target devices visible to the
iPBridge to iSCSI addresses. If you use no arguments, all
devices are mapped to the default target. If you specify a
target, all devices are mapped to that target. If you
specify *, each device is mapped to its own auto-named
target.
Automap <default | * | target name>
SaveConfiguration command required
SaveConfiguration command required
) at startup.
Default: enabled
set AutoMapOnBoot [enabled | disabled]
get AutoMapOnBoot
set AutoMapOnBoot [enabled | disabled]
get AutoMapOnBoot
AutoMapOnBootDelay
Specifies the duration of time in seconds that the iPBridge
waits before performing an
Specifies the duration of time in seconds that the iPBridge
waits before performing an
operation.
specified delay to take effect.
Default: 0
set AutoMapOnBootDelay [0 - 256]
get AutoMapOnBootDelay
set AutoMapOnBootDelay [0 - 256]
get AutoMapOnBootDelay
BridgeModel
Reports specific model and firmware information.
Reports specific model and firmware information.
get BridgeModel
BridgeName
Specifies the eight-character ASCII name assigned to the
iPBridge to identify individual units. It is not the World
Wide Name. Changes take effect immediately.
Specifies the eight-character ASCII name assigned to the
iPBridge to identify individual units. It is not the World
Wide Name. Changes take effect immediately.
set BridgeName [name]
SaveConfiguration Restart command required
get BridgeName
SaveConfiguration Restart command required
get BridgeName
ClearEventLog
Clears the contents of the event log. No new entries are
recorded until the operation is completed.
Clears the contents of the event log. No new entries are
recorded until the operation is completed.
ClearEventLog
TailEventLog
taileventlog
Time
00:00:00
set time 03:32:30
TimeZone
EST
set timezone pst
Username
root
set username barbara
VerboseMode
enabled
set verbosemode disabled
VirtualDriveResponse
disabled
get virtualdriveresponse
VLAN
set vlan dp1 5 alpha1
Command
Default
Example