Siemens D410 Benutzerhandbuch

Commissioning (software) 

 

4.9 Testing the configured drive using the drive control panel 

 

D410 

110

 

Commissioning Manual, 08/2008 Edition 

 

Figure 4-29  Assuming control priority 

4.  Read the notes and confirm these with "Accept". 
5.  Activate the "Enables" checkbox to enable the drive. 

All enables are now set with the exception of ON/OFF1. 

6.  Enter your setpoint in the input field and shift the scaling to 0% as safety setting. 

 

Figure 4-30  Entering the setpoint 

7.  Click the "Drive On" button. The "Enable is set" LED lights up in green color. The drive 

starts moving as you move the slider towards the right side. The current motor speed is 

displayed in "Actual". 

8.  Click "Drive Off" to stop the drive after you completed the test. 
9.  Deactivate the enable signal and click "Give up control priority" to deactivate controlling at 

the programming device / PC.