Infocus IN3916 Benutzerhandbuch

LiteBoard™ Wand

The LiteBoard Wand works like a wireless mouse - but one that works in midair, not 
on your desktop. Just hold the wand in your hand, and point it at the projected 
image to point, click and drag. The wand works with all your software, just like a 
regular mouse.

When the wand’s amber battery light starts to blink, its internal battery is low (if the 
battery is fully discharged, you won’t be able to turn the wand on by pressing its tip, 
left or right buttons).
To charge the battery, open the flap at the bottom of the wand to expose the wand’s 
USB connector. Then connect a USB cable between the wand and the USB power 
adapter, or a computer (if connecting to a computer, make sure the computer is 
powered on). The battery light will stay on while the battery is charging, then it will 
turn off when the battery is fully charged.
When charging is finished, you can disconnect the USB cable (or keep the cable 
connected and use the wand while it’s charging).
NOTE: 5-10 minutes of charging is enough for about an hour of wand use. A full 
charge will take 6-8 hours and will allow 20-40 hours of non-stop wand use. A fully 
charged, new wand will hold a charge in standby for up to 3 weeks.
Caution: The lithium battery is only rechargeable, and is not user serviceable or 
user replaceable.
Caution: Always use the included USB cable and power adapter (or your 
computer) to charge the wand.

The IN3916 projector needs to be powered on and connected to your computer.

Connect the projector and your computer with a USB cable.

Connect the projector and your computer with a VGA cable.

Make sure the wand's battery is charged or charging.

Turn on the projector and make sure it's displaying the computer's screen - set 

the source to VGA 1 or VGA 2 (press the source button on the projector or its 
remote if needed - you may need to press it several times).

Turn on the wand by pressing its tip, left or right button - the wand's blue status 

light will start to blink.

Point the wand at the screen to point, click, and drag - just like a normal mouse. 

The Undo button is located at the bottom of the wand. You can define this 

button in the LiteBoard Wand Menu

NOTE: See LiteBoard Wand Menu below for settings that let you fine-tune wand 
motion and clicking behavior. When you’re done, set the wand aside and make sure 
it isn’t pointing at the screen; it will turn itself off automatically after 1 minute.

You can use the LiteBoard Wand right up against the screen, or around the room. 
You might find that your pointing accuracy will improve if you get closer to the 
screen. Also, avoid standing too far off from either side of the screen.

The wand won't work if its sensor is in a shadow or if it is pointing at a shadow: