Infocus IN3916 Benutzerhandbuch

The blue link light shows the status of the wand's wireless connection to the 
projector. The link light will blink frequently (more than once per second) when the 
wand is attempting to link to the projector; then it will blink less frequently (about 
once every 4 seconds) after the wand has linked to the projector. 
NOTE: The link light will stay off when the wand is off.

The wand's USB connector is behind a flap on the back of the wand. The USB 
connector is only used for charging the wand's battery - using the included USB 
power adapter, or a computer. 
NOTE: You can use the wand while charging the battery, but after the battery is 
charged (battery light turns off), you can unplug the USB cable and continue to use 
the wand without a cable.

The wand's Undo button will function the same as the computer's Escape, Delete, or 
Backspace buttons, or the same as a Ctrl+Z (Windows/Linux) or Cmd+Z (Mac OS) 
command, depending on which function you assign to it in the LiteBoard Wand 
menu. 

The wand's optical sensor opening is located above the wand's tip. Don't block the 
sensor, and make sure it always has a clear view of the screen. 
NOTE: The sensor won't work if you point it at a shadow or away from the screen.

The wand has a reset button, behind a small hole on its underside. Under normal 
conditions, you should not need to reset the wand. See the Troubleshooting section 
below for more information.

The wand has a built-in wireless transmitter/receiver which it uses to communicate 
with the projector.

Manufacturer: HiTech Energy Inc.
Model: E3BE105K1002
Rating: 3.7V/800mAh
Caution: Lithium battery is only rechargeable, and not user replaceable. Not user 
serviceable.

You can access the LiteBoard Wand menu from the projector's Setup menu. To 
change the settings in this menu, highlight a setting, then press Select (on the 
projector or its remote) one or more times - each press of Select will change to the 
next value for the setting.

Enabled: controls whether the projector lets you use LiteBoard Wands. Set this to 
Yes to allow wand use. Set this to No to prevent wand use.

Motion: controls wand motion. When set to Auto, the motion mode will switch 
between Normal, Draw and Stable depending on the image size and distance. 
When set to Normal, motion is set up to work best for normal computer use. When 
set to Draw, motion is set up to work best for on-screen drawing. When set to 
Stable, motion is filtered for maximum stability. When set to Press to Move, the 
mouse pointer only moves when you hold down the wand’s tip or the left button on 
the wand (use the right button to click).

Click Speed: controls the motion pause when you click and only applies if Motion 
is set to Normal or Stable. Longer click speeds will make it easier to double-click, 
but will increase the delay before motion resumes after you click. 

Scroll Button Mode: selects the function of the wand's Scroll Wheel button. You 
can use the Scroll Wheel button to change wand motion, or perform keyboard or 
mouse button shortcuts. 

 

NOTE: The PwrPnt Annotate setting sets up the Scroll Wheel button to control 
drawing (annotating) during Microsoft PowerPoint slide shows. The first press of 
the Scroll Wheel button will turn on the drawing function, the next press will turn 
off the drawing function, the next press will turn it on again, etc.

Undo Button: selects the function of the wand's undo Button.

Link Channel: selects the radio channel used for wand communication. This 
should be set to Auto unless you encounter interference (see Troubleshooting below 
for more information).