Primera Technology RX900 Benutzerhandbuch

A: SETUP

RFID Label Stock should have an 

antenna

 imbedded between

the label adhesive layer and the liner.  The antenna should be

oriented to the front of the label stock and centered within the

label.

Follow these instructions each time you load a new roll of

RFID Label Stock.
1. Load your RFID label stock according to the instructions

printed on the inside cover of your RX900 and found in

Section 2B. 

2. Before you start printing, adjust the slide bar so the

Reader/Writer marker is approximately 1/8" (3mm) left or

right from center chip of the antenna.  Open the cover of

the printer. You will find the slide bar and marker near the

front of the printer right behind the tear bar.

Label

RFID Chip

Antenna

Set Marker approxi-

mately 1/8" (3mm) left

or right from center

chip of antenna.

RFID Read/Write Marker

Tear Bar

Slide Bar Handle

Antenna

RX900.qxd  2/17/2011  1:28 PM  Page 17