Primera Technology RX900 Benutzerhandbuch

Using RFID

Note: Write success is less likely as you move the marker away from the

center of the label.

Important Note: The remaining steps are optional and only necessary if

encoding problems are present. If you are loading a new roll with the

exact same specifications as the last roll, none of these steps will be

necessary.

3. Open the PTStatus Monitor to test write to the RFID chip

and verify the correct position of the Reader/Writer. Go

Start - All Programs - Primera Technology - PTStatus.

Click on the RFID tab.

4. Click "Calibrate". PTStatus will automatically calibrate

optimal position and Antenna Power. This process may

take up to three minutes. During this time the stock

position and antenna power are automatically adjusted.

After this, ten write and ten verification reads are

performed on the same label.

5. Writing Test. If further testing is desired or if the automatic

calibration failed you can perform a writing test. Select the

Writing Test button to start.
The RX900 will write to the same label continuously until

"Stop Test" is selected. The results of each test will be dis-

played in PTStatus. During this time you can adjust the

Slide Bar if necessary until you receive a successful test. If

the test is not successful you will see a "Write Failed" error.

Set Marker

approximately

1/8" (3mm) left

or right from

center chip of

antenna.

RX900.qxd 2/17/2011 1:28 PM Page 18

TOC

INDEX