Primera Technology RX900 Benutzerhandbuch

C. OTHER FUNCTIONS

Batch Reading Test. (Optional) After printing and encoding

labels you may run a Batch reading test to verify that each

label was encoded successfully.  Simply load the printed roll,

open the status monitor and choose Batch Reading Test on the

RFID tab.
Move to next tag.  Before reading, writing or calibrating, select

Move to next tag to instruct the printer to feed the label stock

to the next tag/label. 
Print and encode.  Use this interface to test printing and

encoding.  Be sure to set your label size via the printer driver

settings accessible in printer preferences as described in

Section 5F.

(lower right on RFID tab).  Click this to access and

advanced encoding interface.  This interface will allow

you to communicate directly with the RFID module via text

commands.  Do not use this interface unless directed to do so

by tech support. 
Advanced Options.  Access advanced options by clicking the

icon on the top right side of the status monitor.  Click the

options button.  There are

several options available.  Below

are the options that concern

RFID encoding.
Print 'XXXX' on RFID Failure.

By default a series of XXXXs will

automatically be printed on the

label to indicate that it was not

encoded properly.  If you disable

this option nothing will be print-

ed on an encoding failure.
Unpresent Time. This is the time

between the finish of the print

and when the printer moves the

stock back into position for the

next encoding/printing.  The purpose of this setting is to allow

a specific amount of time to remove the label after a one off

print.
Unpresent Position. This is the position the label stock moves

to after the unpresent time has elapsed. This should be set to

RFID Tag when printing and encoding RFID labels. 

RX900.qxd  2/17/2011  1:29 PM  Page 20