Zebra Technologies 105SL Benutzerhandbuch
Routine Maintenance
Cleaning Schedule
11342L Rev. 8 6/4/2004
105SL User Guide
75
Figure 43 • Snap Plate Reinstallation
6.
Slide the snap plate toward you.
7.
Press down on the loops to lock the snap plate into place.
Cutter Module
(For printers equipped with the optional cutter.)
If labels are not being cut properly or if the cutter jams with labels, turn off the printer power
(O) and unplug the printer. Then, clean the stationary cutter blade with cleaning solvent. This
removes label adhesive and/or paper debris. If further cutter cleaning is necessary, or if the
cutter continues to perform unsatisfactorily, contact an authorized service technician.
(O) and unplug the printer. Then, clean the stationary cutter blade with cleaning solvent. This
removes label adhesive and/or paper debris. If further cutter cleaning is necessary, or if the
cutter continues to perform unsatisfactorily, contact an authorized service technician.
Note •
Turning off the printer results in the loss of label formats, images, and any temporarily
saved parameter settings stored in the printer’s internal memory. Perform this procedure after
your printing job is complete.
your printing job is complete.