Frymaster SinBaD Series Benutzerhandbuch
3-3
PROBLEM
Probable Causes
Corrective Action
B.
If the erratic batch weights are
occurring consistently, the probable
cause is a misaligned component.
occurring consistently, the probable
cause is a misaligned component.
B.
Verify that the dispensing chute is
properly positioned on the load cell
arms, that the deflector is properly
positioned in the hopper, and that
the hopper is fully seated behind
the locking rim on the cradle
assembly.
properly positioned on the load cell
arms, that the deflector is properly
positioned in the hopper, and that
the hopper is fully seated behind
the locking rim on the cradle
assembly.
Continued from
previous page.
If one of the above actions does not correct the problem, there may be a problem
with the programmed weight settings or the load cell. Call FASC.
with the programmed weight settings or the load cell. Call FASC.
A.
Unit was not in STANDBY mode
when attempt was made to enter
CLEAN mode.
when attempt was made to enter
CLEAN mode.
A.
The CLEAN mode can only be
selected when the unit is in the
STANDBY mode.
selected when the unit is in the
STANDBY mode.
Press the RUN Switch once to
place the unit in the STANDBY
mode, and then press the CLEAN
Switch.
place the unit in the STANDBY
mode, and then press the CLEAN
Switch.
UNIT WILL NOT GO
INTO CLEAN MODE.
If the above action did not correct the problem, call FASC.