AEG PV.500-MH Benutzerhandbuch

Seite von 68
Protect PV.500-MH Operating Instructions 
50 of 68 
80000043212 BAL 
 
7.1.4.2 Configuring the Modbus Protocol 
To access the X5 data protocol configuration, you must press <4> 
in the main menu: 
 
Figure 19 
Data protocol configuration 
Press one of the following keys in the “X5 Data Protocol” menu: 
<TAB> to configure the Modbus protocol 
<CR> to accept the set values. The configuration is finished and 
the main menu is opened again.  
<ESC> to cancel the configuration. This opens the main menu.
 
 
 
Figure 20 
Modbus protocol configuration 
Press one of the following keys in the “X5 Data Protocol – Mod-
bus/JBusV2” menu: 
  <!> to load the factory setting. 
  <1> to configure the Modbus slave address. 
  <2> to configure the delay time between a request from the 
master and the response from the slave.  
  <CR> to accept the set values. The configuration is finished 
and the main menu is opened again.  
  <ESC> to cancel the configuration. This opens the main menu. 
downloadlike
ArtboardArtboardArtboard