Blomberg IWD 1006 XT Benutzerhandbuch

EN

18

C

 Water mains pressure must not be 

over 8 bars.

C

 Pumps must be used in case the 

supply water pressure drops below 1 bar 
or if a jug is going to be used.

1.  Separate the union from the tap 

adaptor. (Figure A) 

2.  Install the tap adaptor to 1/2” valve 

fitting as shown in the figure. (Figure B) 

3.  After inserting the water pipe to the 

union, install it to the tap adaptor and 
insert to the tap as shown in the figure. 
(Figure C) 

4.  Tighten the union manually. In case of a 

leak use a spanner or a pair of pliers to 
tighten the union. 

A

 Warning: Secure the water pipe 

to suitable points by means of the 
pipe clips supplied to avoid any 
damage or displacement or accidental 
disconnection.

A

 Warning: After turning on the water 

valve, make sure that there is no leakage 
at both connection points of the water 
pipe. In case of a leak, turn off the valve 
immediately and tighten all joints again 
using a spanner or a pair of pliers.

A

 Warning: Make sure that standard 

1/2" valve fitting fed by cold mains water 
supply is available and is turned off fully. 
Note -1:  There is no need to use water 

filter in case a jug is used.

Note -2:  Pump must be used when jug will 

be used.

 

C

 Water mains pressure must not be 

below 1 bar.