Combi 8100 Benutzerhandbuch

After selecting a seating location,
if adjustable, adjust vehicle seat 
back into most upright position.

Rotate car seat on lower base to 
forward-facing position, see “Changing 
Forward-Facing/Rear-Facing Use 
Position” section.

Remove the lower anchor connectors 
from their storage locations on back 
of car seat pad (fig. a).

- Depress spring on hook-on 

connector (fig. b) and remove 
from LATCH connector storage
ring. 

Lengthen lower anchor belt by pressing 
down on belt adjuster slide button on 
top of belt adjuster and pulling belt to 
extend the length of lower anchor belt 
(fig. c).

Check that the lower anchor belt is through  
the belt path openings marked “Belt Here 
Forward-facing” (fig. d). If lower anchor belt is not
through the forward-facing belt path openings, see 
“LATCH - Changing Belt Path Location” section.

Place car seat forward-facing in the 
vehicle seat location selected with 
forward-facing belt path toward vehicle 
seat back and centered between the 
vehicle lower anchors (fig. d).

Adjust car seat to desired recline position 
1, 2 or 3. 

- To change recline position, see “Recline Position 

Adjustment” section.

Connect lower anchor connectors to vehicle lower anchors.

- Position the lower anchor belt with the belt adjuster 

slide button facing away from the car seat. If the adjuster 
is not in that position, turn the belt and adjuster over. 
Check that lower anchor belt is flat,not twisted.

- With hook-on connector opening facing down    , 

position the opening of the connector over the 
vehicle lower anchor. Push down     and then
pull out     on the connector to lock it onto the 
vehicle anchor (fig. e). You should hear a click.

- Pull on connector to be sure it is locked onto 

the anchor.

- Repeat for connector on 

opposite side.

1

2

3

2

3

1