Cub Cadet 928 SWE Benutzerhandbuch

With the mounting holes toward the back, slide the new 

4. 

shave plate into position and secure with the fasteners 

removed previously.

The gear (hex) shaft should be lubricated at least once a season 

or after every twenty-five (25) hours of operation.

Carefully pivot the snow thrower up and forward so that it 

1. 

rests on the auger housing. 
NOTE: Before pivoting snow thrower up and forward, be 

sure to run the fuel tank dry to prevent leakage of fuel.
Remove the frame cover from the underside of the snow 

2. 

thrower by removing four self-tapping screws which secure 

it. 
Apply a light coating of engine oil (or 3-in-1 oil) to the hex shaft. 

3. 

See Fig. 6-2.

NOTE: When lubricating the hex shaft, be careful not to get any 

oil on the aluminum drive plate or the rubber friction wheel. 

Doing so will hinder the snow thrower’s drive system. Wipe off 

any excess or spilled oil.

At least once a season, remove all four wheels. Clean and coat the 

axles with a multipurpose automotive grease before reinstalling 

wheels.

Once a season, lubricate the chute crank bracket bushing and the 

spiral with 3-in-1 oil.

Refer to the Briggs & Stratton Engine  manual packed with your 

machine for all engine maintenance.

The shave plate and skid shoes on the bottom of the snow 

thrower are subject to wear. They should be checked periodically 

and replaced when necessary.
NOTE: The skid shoes on this machine have two wear edges. 

When one side wears out, they can be rotated 180° to use the 

other edge.
To Remove skid shoes:

Remove the six carriage bolts, hex nuts, and bell washers 

1. 

that secure the two skid shoes to the sides of the auger 

housing. Refer to Figure 6-1.
Position the new skid shoes and secure with the carriage 

2. 

bolts, bell washers, and hex nuts. Make certain the skid 

shoes are adjusted to be level. See Figure 6-1.

To replace shave plate:

Remove the hex nuts, bell washers, and carriage bolts that 

1. 

secure the shave plate to the bottom of the snow thrower 

housing.
Remove the rear most hex nut, bell washer, and carriage bolt 

2. 

securing the back of each skid shoe to the sides of the 

housing. Loosen the remaining hex nuts securing the skid 

shoes.
Slide the shave plate out of the off-set slot at the bottom of the 

3. 

housing, and from between the skid shoes and side panels 

of the housing.