Cub Cadet 928 SWE Benutzerhandbuch

At least once a season, one at a time, remove the shear pins from 

the  auger shaft. Spray lubricant inside the hub of each auger 

spiral assembly and around the spacers on the auger shaft. 
Grease fittings can also be found at each end of the auger shaft. 

Lubricate flange bearings found at each end of the shaft with a 

grease gun once a season. See Figure 6-3.

The auger gear case is equipped with a grease fitting. Lubricate 

with Shell Alvania lead-free grease (737-0168) once a season. See 

Figure 6-3.
NOTE: To relieve pressure, remove the vent plug before 

lubricating the gear case. See Figure 6-3. Failure to do so could 

result in damage to the gear case seals. 

Each of the six auger spiral assemblies is secured to the spiral 

shaft with a shear pin and cotter pin. If the auger should strike a 

foreign object or ice jam, the snow thrower is designed so that 

the pins may shear.  

If augers do not turn, check to see if pins have sheared. 

1. 

Replace the pins if needed. Two replacement shear pins and 

2. 

cotter pins have been provided with the snow thrower. 

Spray an oil lubricant into shaft before inserting new pins 

and securing with new cotter pins.

If the full range of speeds (forward and reverse) cannot be 

achieved, refer to the figure to Figure 6-4 and adjust the shift rod 

as follows:

Looking underneath the handle panel, note which of the three 

1. 

holes in the shift lever the ferrule is inserted into. Also note 

the direction of insertion. Then remove the internal cotter 

pin and flat washer from the ferrule and withdraw the 

ferrule from the shift lever. See Figure 6-4.
Place shift lever in sixth (6) position or fastest forward speed.

2. 

Push shift rod and shift arm assembly down sharply as far as it 

3. 

will go to shift the drive into the fastest forward position.
As necessary, rotate the ferrule up or down the shift rod until 

4. 

the ferrule lines up with the hole from which it was earlier 

removed. See Figure 6-4.
From the direction noted earlier, insert the ferrule into the proper 

5. 

hole. Reinstall the washer and secure with the internal 

cotter pin.

If the spiral at the bottom of the chute directional control is not 

fully engaging with the chute assembly, the chute bracket can be 

adjusted. To do so:

Loosen the two nuts which secure the chute bracket and 

1. 

reposition it slightly. Refer to Figure 6-5.
Retighten the nuts.

2.