Dimplex Electric Fireplace Benutzerhandbuch

The fireplace can be installed with wall-mounted 
controls in addition to the controls provided.  
These controls include wall switches and 
thermostats. 
A.  Wall Mounted Thermostats 
ALL MODELS WITH REMOTE CONTROL. 
When the fireplace is set to Level 2, or Level 3 the 
wall mounted thermostat will control the heat 
output of the unit.  When the fireplace is set to 
Level 2, or 3 the heater will not activate until the 
wall mounted thermostat senses an ambient 
temperature lower than the temperature to which it 
is set. 
B.  Wall Mounted Switches 
ALL MODELS WITHOUT REMOTE CONTROL 
ONLY. 
This model may be installed such that a wall-
mounted switch activates the flame effect and a 
wall mounted thermostat activates the heater.   

The heater on this fireplace is protected with a 
safety device to prevent overheating.  Should the 
heater overheat, an automatic cut out will turn the 
heater off and it will not come back on without 
being reset.  It can be reset by switching the Main 
Power switch (FIGURE 3) to OFF and waiting 5 
minutes before switching it to ON.  The remote 
control will need to be re-initialized (see page 2) 
 

 

 
 
 
 

 

 

• 

If you need to continuously reset the 
heater, disconnect the power at the main 
service panel and call your local dealer. 

• 

The heater may emit a slight, harmless 
odor when first used.  This odor is a 
normal condition caused by initial heating 
of internal heater parts and will not occur 
again. 

4