Dimplex Electric Fireplace Benutzerhandbuch

 

 

To access the light bulb area: 
1.  Open steel curtain (remove glass doors if 

applicable). 

2.  Remove two screws on log grate and remove 

log grate (FIGURE 4). 

3.  Pull rear edge of ember bed up and forward by 

grasping ember bed by the sides (handle the 
logset only by the emberbed and not the logs) 
and pulling solidly until the rear tab pops out 
from under the back ledge, then lift out.  
(FIGURE 5) 

4.  Examine the bulbs to determine which bulbs 

require replacement. 

5.  Unscrew bulbs counter clockwise. 
6.  Insert new bulbs. 
7.  Replace the log by inserting front edge and 

pushing the back down until rear tab snaps 
under back ledge (FIGURE 5) and the logs are 
resting against mirror. 

8.  Replace log grate using two screws previously 

removed. 

 

The mirror is cleaned in the factory during the 
assembly operation.  During shipment, installation, 
handling, etc., the mirror surface may collect dust 
particles; these can be removed by buffing lightly 
with a clean dry cloth. 
To remove fingerprints or other marks, the mirror 
can be cleaned with a damp cloth using good 
quality household glass cleaner.  The mirror should 
be completely dried with a lint free cloth or paper 
towel. 

 
 
 

 

 

• 

Do not use abrasive cleaners on mirror 
surface or spray liquids directly onto any 
surface. 

FIGURE 4 

FIGURE 5 

6