Quantum DLT-S4 Betriebsanweisung
Chapter 11 Installing an Internal SAS Tape Drive
Connecting the Cables
DLT-S4 Product Manual
95
Connecting the Cables
11
Connect the SAS and power cables as follows:
1
Ensure that both the tape drive and computer are turned off.
2
Insert the SAS cable into the SAS port on the rear of the tape drive
).
3
Insert the other end of the SAS cable into the SAS port on the host
computer.
4
Locate an available DC power cable in the host computer and attach
it to the power connector on the rear panel of the tape drive (see
). The connector is keyed, preventing improper connection.
(See
number assignments and signal names.)
5
Check all the cable and termination connections to ensure that they
are attached correctly, seated firmly, and secured.
Note:
If you are connecting several devices to the system,
connect only the tape drive to the host computer at this
time. Finish the installation procedure and confirm that
the host computer and tape drive are communicating
correctly before adding additional devices (see