Quantum DLT-S4 Betriebsanweisung
Chapter 11 Installing an Internal SAS Tape Drive
Adding Additional Devices
DLT-S4 Product Manual
97
Adding Additional Devices
11
Once you have successfully confirmed the installation of your tape drive,
you may add additional devices.
For each additional device:
For each additional device:
1
Ensure that both the tape drive and host computer are turned off.
2
Insert the SAS cable into the SAS port on the device (for tape drives,
see
).
3
Insert the other end of the SAS cable into the SAS port on the host
computer.
4
Check all cable connections and ensure that they are attached
correctly and seated firmly before turning the system on.
5
Confirm the installation (see
Using the Loader/Library Interface Connector
11
This connector is only used for tape drives installed in loaders/libraries.
If your system requires it to be used, it should have been pre-assembled
at the factory. For more information about the loader/library connector,
see
see