Quantum DLT-S4 Betriebsanweisung
Chapter 12 Installing the Tabletop Tape Drive
Equipment Required
DLT-S4 Product Manual
99
Equipment Required
12
You need the following items to install the tape drive in a system:
• Four (4) M3 x 8 mm long screws
• Screwdriver
• Ultra320-rated SCSI cable and terminator (supplied)
• Ultra320-capable host bus adapter (HBA)
• Four (4) M3 x 8 mm long screws
• Screwdriver
• Ultra320-rated SCSI cable and terminator (supplied)
• Ultra320-capable host bus adapter (HBA)
Installation Steps
12
To install the tape drive, perform the following tasks in this order. Each
task is described in detail on the pages listed below.
Caution:
Before you begin, review the safety, ESD, and handling
precautions described in
to avoid personal
injury or damage to equipment.
Note:
The tabletop model comes ONLY with the SCSI interface. The
Fibre Channel and SAS interfaces are not available.
Step No.
Step
Page
1
Unpack the tape drive.
2
Select a location for the tape drive.
3
Set the SCSI ID.
4
Connect the tape drive to the host
computer and terminate the SCSI bus.