Quantum LTO-2 Installationsanweisungen

 

 

 

Figure 1. Diagram of Drives with Leader Pin Inside LTO Cartridge (Tape Not Threaded on Take-up Hub) 

If the cartridge is loaded and seated and the leader pin is still inside the cartridge, follow these steps to 
remove the cartridge. To remove the cartridge you will need a small, flat-blade screwdriver 

  Verify that the leader pin is still inside the cartridge as shown in Figure 1Error! Bookmark not 

defined.. If the leader pin has been pulled out of the cartridge and is still in the tape path, follow the 
steps in “ Cartridge is Loaded and Seated with Tape Threaded” on page 44. 

  Use a flat-blade screwdriver to turn the worm gear counter clockwise (to the left). Figure 2 on page 3 

shows the location of the worm gear. This will gradually raise the cartridge elevator and cause the 
cartridge to slide partially out of the drive. 

 

NOTE: Do not touch any other part of the drive mechanism during this process.