Champion pp-3 Benutzerhandbuch

C O N T R O L   P A N E L S  
 

 
Operation Modes 

 

This mode is entered when the operator drains the water,  and as part of the Change Water 
procedure, a Dry Fire has occurred. 

¾  Display shows fil

  

¾  Change Water indicator light is OFF 
¾  Alarm indicator light is on until al.1 is off 
¾  Heater is disabled 

¾  Pumps are disabled 
¾  Soap Pump is disabled 

 
When the tank is filled with new water, the heater will become immersed and the al.1 alarm 
will be cleared. 
 
If the al.1 alarm has cleared, it is possible to place the controller into the RUN STATE by 
pressing the START/STOP button. 
 
 

¾  Display shows the water temperature 

¾  Change Water indicator light is off 
¾  Heater is enabled 

¾  Pumps are ON 
¾  Soap Pump is enabled 
¾  When the controller changed the status from the fil state, timers t and t2 were 

reset and restarted. 

¾  When timer t2 expires, timer t3 starts 
¾  When timer t3 is active, the soap pump and soap indicator light is on 
¾  When time t3 has expired, the soap pump and soap indicator light is off 

 
The controller changes from the RUN STATE to the DRAIN STATE when timer t has 
expired. 
 
The activation of alarm a l . 1  will automatically place the controller into the FILL STATE. 
 

Pressing the START/STOP button will cause the controller to change to the STOP STATE. 
Timer t pauses and the pumps are turned off. 

 

 

If the UP and START/STOP buttons are pressed for more than 15 seconds, then the timers 
are reset and controller changes to the FILL STATE.

23