Enterasys csx200 Betriebsanweisung

146

CSX200 Family User’s Guide

The line configuration information shown in 

 must be supplied by the service provider.

Begin the physical configuration by accessing the WAN Physical Configuration screen through 
Local Management. Proceed with the following steps:

Use the arrow keys to highlight Time Slot View. Press the SPACEBAR until NEW displays, 
then press ENTER. The cursor moves to Time Slot #1 of the Time Slot Configuration Table.

Insert an interface number (see NOTE below) into every Time Slot being used (in the example 
shown in 

number, press ENTER, then use the arrow keys to highlight the next Time Slot field. Exit this 
field by using the arrow keys.The cursor automatically moves to the T1 Line Coding field.

Use the arrow keys to highlight T1 Line Coding. Use the SPACEBAR to select B8ZS or AMI, 
then press ENTER.

Use the arrow keys to highlight T1 Frame Type. Use the SPACEBAR to select ESF or D4, 
then press ENTER.

Line Coding

B8ZS or AMI

Frame Type

ESF or D4

Clock Source

Loop Timing or Local Timing

DS-0s (Time Slots)

Time Slots being used for each end of 
the circuit

The value assigned to the Time Slots is the interface being used for WAN 
communication. The available interface range is displayed on the WAN Physical 
Configuration screen. You may insert any of the available interface numbers into the 
Time Slots.

In the example shown in 

, the interface range for the CSX200 is 2–25. 

Although any of these values may be used, Cabletron Systems recommends using the 
first available interface number (in this example interface #2).

The following four steps are based on information supplied by the service provider. 
Consult the service provider for the correct settings.