Fortinet fortigate-5001a Hardwarehandbuch
FortiGate-5000 Series Hardware Guide
80
01-00000-0293-20060315
Removing a FortiGate-5002FB2 module from a chassis
FortiGate-5002FB2 security system
8
Fully tighten the left and right mounting knots to lock the FortiGate-5002FB2
module into position in the chassis slot.
.
module into position in the chassis slot.
.
If the chassis is powered on the PWR LED turns green and the STATUS LED
turns RED. After a few minutes, if the module is operating correctly the front panel
LEDs are lit as described in
turns RED. After a few minutes, if the module is operating correctly the front panel
LEDs are lit as described in
9
Gently push the extraction lever lock up to make sure the extraction levers are
locked.
locked.
Removing a FortiGate-5002FB2 module from a chassis
The following procedure describes how to correctly use the FortiGate-5002FB2
mounting components shown in
mounting components shown in
to remove a FortiGate-5002FB2
module from a FortiGate-5000 series chassis slot.
To remove a FortiGate-5002FB2 module from a FortiGate-5000 series
chassis
chassis
FortiGate-5002FB2 modules are hot swappable. The procedure for removing the
FortiGate-5002FB2 module from a FortiGate-5000 series chassis slot is the same
whether or not the FortiGate-5000 series chassis is powered on or not.
FortiGate-5002FB2 module from a FortiGate-5000 series chassis slot is the same
whether or not the FortiGate-5000 series chassis is powered on or not.
Table 14: FortiGate-5002FB2 normal operating LEDs
LED
State
STATUS
Green
PWR
Green
IPM
Off
Tighten
Mounting
Knot
Extraction
Lever
Extraction Lever
Lock