Fortinet fortigate-5001a Hardwarehandbuch

 lists and describes the FortiSwitch-5003 connectors.

The following procedure describes how to correctly use the FortiSwitch-5003 
mounting components shown in 

 to insert a FortiSwitch-5003 module 

into a FortiGate-5000 series chassis slot. The FortiSwitch-5003 module left 
extraction lever contacts a hidden power switch.

The FortiSwitch-5003 module left extraction lever contacts to a hidden power 
switch. The module must be fully installed in a chassis slot and this extraction 
lever must be closed and locked for the FortiSwitch-5003 module to receive power 
and operate normally. If the FortiSwitch-5003 module is not receiving power, the 
Hot Swap LED glows blue and all other LEDs remain off.

Green

Initialization completed successfully.

Yellow

Cannot establish a link to a configured port or another 
connection problem external to the adaptor.

Yellow

Failure of internal tests. Off during power up.

Blue

Light on indicates the switch is ready to remove. During a hot 
swap, LED is on. LED turns off when the switch is correctly 
installed.

Press and hold Reset for three seconds to restart the switch.

Change the port LED display function from Link/Activity mode 
to Link/Speed mode.

RJ-45 100Base-T

Ethernet

Ethernet out of band management 
connection.

CONSOLE RJ-45 9600 bps

RS-232 
serial

Serial connection to the command line 
interface.

RJ-45 1000Base-T Ethernet

Redundant connections to another 
FortiGate chassis.