Frigidaire fgf379wesr Installationsanweisungen

30" GAS RANGE INSTALLATION INSTRUCTIONS

(For Models with Sealed Top Burners)

Important Notes to the Installer

1. Read all instructions contained in these installation

instructions before installing range.

2. Remove all packing material from the oven

compartments before connecting the gas and electrical

supply to the range.

3. Observe all governing codes and ordinances.

4. Be sure to leave these instructions with the consumer.

Important Note to the Consumer

1. Keep these instructions with your owner's guide for

future reference.

IMPORTANT SAFETY

INSTRUCTIONS

Installation of this range must conform with local codes or,

in the absence of local codes, with the National Fuel Gas

Code ANSI Z223.1latest edition when installed in the

United States. When installed in Canada, installation must

conform with CAN/CGA-B149.1 and CAN/CGA-B149.2.

This range has been design certified by the American Gas

Association and the Canadian Gas Association. As with any

appliance using gas and generating heat, there are certain

safety precautions you should follow. You will find them in

the Owner's Guide, read it carefully.

Be sure your range is installed and grounded properly

by a qualified installer or service technician.

This range must be electrically grounded in

accordance with local codes or, in their absence,

with the National Electrical Code ANSI/NFPA

No .70latest edition when installed in the United

States. When installed in Canada, this range must be

electrically grounded in accordance with CSA Standard

C22.1, Canadian Electrical Code, Part 1. See Grounding

Instructions on page 5.

Before installing the range in an area covered with

linoleum or any other synthetic floor covering,

make sure the floor covering can withstand heat at

least 90°F above room temperature without

shrinking, warping or discoloring. Do not install the

range over carpeting unless you place an insulating

pad or sheet of 1/4-inch thick plywood between the

range and carpeting.

Make sure the wall coverings around the range can

withstand the heat generated by the range.

Do not obstruct the flow of combustion air at the

oven vent nor around the base or beneath the lower

front panel of the range. Avoid touching the vent

openings or nearby surfaces as they may become hot

while the oven is in operation. This range requires fresh

air for proper burner combustion.

Never leave children alone or unattended

in the area where an appliance is in use. As children

grow, teach them the proper, safe use of all appliances.

Never leave the oven door open when the range is

unattended.

Stepping, leaning or sitting on the doors

or drawers of this range can result in serious injuries

and can also cause damage to the range.

Do not store items of interest to children in the

cabinets above the range. Children could be seriously

burned climbing on the range to reach items.

To eliminate the need to reach over the surface

burners, cabinet storage space above the burners

should be avoided.

Adjust surface burner flame size so it does not

extend beyond the edge of the cooking utensil.

Excessive flame is hazardous.

Do not use the oven as a storage space. This creates

a potentially hazardous situation.

Never use your range for warming or heating the

room. Prolonged use of the range without adequate

ventilation can be dangerous.

Do not store or use gasoline or other flammable

vapors and liquids near this or any other appliance.

Explosions or fires could result.

Reset all controls to the "off" position after using a

programmable timing operation.

FOR MODELS WITH SELF-CLEAN FEATURE:

 Remove broiler pan, food and other utensils before

self-cleaning the oven. Wipe up excess spillage. Follow

the precleaning instructions in the Owner's Guide.

Unlike the standard gas range, THIS COOKTOP IS

NOT REMOVABLE. Do not attempt to remove the

cooktop.

DO NOT MAKE ANY ATTEMPT TO OPERATE

THE ELECTRIC IGNITION OVEN DURING AN ELECTRICAL

POWER FAILURE. RESET ALL OVEN CONTROLS TO "OFF"

IN THE EVENT OF A POWER FAILURE.

The electric ignitor will automatically re-ignite the oven

burner when power resumes if the oven thermostat

control was left in the "ON" position.

When an electrical power failure occurs during use, the

surface burners will continue to operate.

During a power outage, the surface burners can be lit with

a match. Hold a lighted match to the burner, then slowly

turn the knob to the LITE position. Use extreme caution

when lighting burners this way.