Frigidaire fgf379wesr Installationsanweisungen

For leveling legs and Anti-Tip Bracket:
• Adjustable wrench or channel lock pliers 
• 5/16" Nutdriver or Flat Head Screw Driver 

• Electric Drill & 1/8" Diameter Drill Bit (5/32" Masonry

Drill Bit if installing in concrete)

 

For gas supply connection:
• Pipe wrench  

• Phillips head  

  and

blade-type screwdrivers  

For gas conversion (LP/Propane or Natural):
• Open end wrench - 1/2"  

• Gas line shut-off valve  
• Pipe joint sealant that resists action of LP/Propane gas

• A new flexible metal appliance conduit (1/2" NPT x  3/

4" or 1/2" I.D.) must be AGA/CGA design certified.

Because solid pipe restricts moving the range we

recommend using a new flexible conduit  (4 to 5 foot

length) for each new installation and additional

reinstallations.

 

   

   

• Always use the (2) new flare union adapters (1/2" NPT

x 3/4" or 1/2" I.D.) supplied with the new flexible

appliance conduit for connection of the range.

To reduce the risk of tipping of the range, the range must

be secured to the floor by properly installed anti-tip bracket

and screws packed with the range. Failure to install the

anti-tip bracket will allow the range to tip over if excessive

weight is placed on an open door or if a child climbs upon

it. Serious injury might result from spilled hot liquids or

from the range itself.
If range is ever moved to a different location, the anti-tip

brackets must also be moved and installed with the range.
Instructions are provided for installation in wood or cement

fastened to either the floor or wall.  When installed to the

wall, make sure that screws completely penetrate dry wall

and are secured in wood or metal.  When fastening to the

floor or wall, be sure that screws do not penetrate electrical

wiring or plumbing.

A. Locate the Bracket Using the Template - (Bracket may

be located on either the left or right side of the range.

Use the information below to locate the bracket if

template is not available).  Mark the floor or wall where

left or right side of the range will be located.  If rear of

range is against the wall or no further than 1-1/4" from

wall when installed, you may use the wall or floor

mount method. If molding is installed and does not

allow the bracket to fit flush against the wall, remove

molding or mount bracket to the floor. For wall mount,

locate the bracket by placing the back edge of the

template against the rear wall and the side edge of

template on the mark made referencing the side of the

range. Place bracket on top of template and mark

location of the screw holes in wall.  If rear of range is

further than 1-1/4" from the wall when installed, attach

bracket to the floor.  For floor mount, locate the

bracket by placing back edge of the template where

the rear of the range will be located.  Mark the location

of the screw holes, shown in template.

B. Drill Pilot Holes and Fasten Bracket - Drill a 1/8" pilot

hole where screws are to be located.  If bracket is to be

mounted to the wall, drill pilot hole at an approximate

20° downward angle. If bracket is to be mounted to

masonry or ceramic floors, drill a 5/32" pilot hole 1-3/

4" deep. The screws provided may be used in wood or

concrete material.  Use a 5/16" nut-driver or flat head

screwdriver to secure the bracket in place.