Frigidaire fgf379wesr Installationsanweisungen

C. Level and Position Range - Level range by adjusting

the (4) leveling legs with a wrench. Note: A minimum

clearance of 1/8" is required between the bottom of the

range and the leveling leg to allow room for the

bracket.  Use a spirit level to check your adjustments.

Slide range back into position.  Visually check that rear

leveling leg is inserted into and fully secured by the

Anti-Tip Bracket by removing lower panel or storage

drawer. For models with a warmer drawer or broiler

compartment, grasp the top rear edge of the range and

carefully attempt to tilt it forward.

This unit is pre-set to operate on 4" natural gas manifold

pressure. A convertible pressure regulator is connected to

the manifold and MUST be connected in series with the gas

supply line. If the LP/Propane conversion kit has been used,

follow instructions provided with the kit for converting the

pressure regulator to LP/Propane use.

Care must be taken during installation of range not to

obstruct the flow of combustion and ventilation air.

For proper operation, the maximum inlet pressure to the

regulator should be no more than 14 inches of water

column pressure. The inlet pressure to the regulator must

be at least 1 inch greater than regulator manifold pressure.

Examples: If regulator is set for natural gas 4 inch manifold

pressure, inlet pressure must be at least 5 inches; if regulator

has been converted for LP/Propane gas 10 inch manifold

pressure, inlet pressure must be at least 11 inches.

Leak testing of the appliance shall be conducted according

to the instructions in step 4g.

The gas supply line should be 1/2" or 3/4" I.D.

Seal any openings in the wall behind the range and in the

floor under the range after gas supply line is installed.

To prevent leaks, put a pipe joint sealant on all male

(outside) pipe threads.

Your regulator is in the location shown below.