WatchGuard x1000 Hardwarehandbuch
Hardware Description
Hardware Guide
23
(NICs) are auto-sensing and adapt to wire speed automatically. The
speed indicator lights when there is a good physical connection to the
Firebox. When the card runs at 10Mbit, the speed indicator is yellow.
When the card runs at 100 Mbit, the speed indicator is green. The
amber traffic indicator blinks when traffic is passing through the
Firebox.
speed indicator lights when there is a good physical connection to the
Firebox. When the card runs at 10Mbit, the speed indicator is yellow.
When the card runs at 100 Mbit, the speed indicator is green. The
amber traffic indicator blinks when traffic is passing through the
Firebox.
Physical specifications (All models except Model 700)
•
Three RJ-45 10/100Tx Ethernet interfaces
•
1 DB-9 serial port
•
PCI expansion option
•
500 MHz AMD K6-III processor
300 MHz AMD K6-II processor (model 1000 only)
300 MHz AMD K6-II processor (model 1000 only)
•
64-MB SDRAM (model 1000)
128-MB SDRAM (model 2500)
264-MB SDRAM (model 4500)
128-MB SDRAM (model 2500)
264-MB SDRAM (model 4500)
•
8-MB flash disk
•
100-240 VAC Autosensing, 50/60 Hz
•
Height: 2.85”; Width: 15.5 “; Depth: 10.5”
Physical specifications (Model 700)
•
Three RJ-45 10/100Tx Ethernet interfaces
•
1 DB-9 serial port
•
233 MHz AMD K6-II processor
•
64-MB SDRAM
•
8-MB flash disk
•
100-240 VAC Autosensing, 50/60 Hz
•
Height: 2.85”; Width: 15.5 “; Depth: 10.5”
Cross-over cabling
To connect a Firebox to a hub or switch, use a standard, straight-through
cable. However, if you plan to connect a Firebox directly to a router, either
purchase or build a cross-over cable for RJ-45 (Cat5) wire.
cable. However, if you plan to connect a Firebox directly to a router, either
purchase or build a cross-over cable for RJ-45 (Cat5) wire.