ONKYO TX-SA806 Betriebsanweisung
100
If you’ve connected your Zone 2 speakers to the AV
receiver/AV amplifier, as explained in “Connecting Your
Zone 2 Speakers Directly to the AV receiver/AV ampli-
fier” on page 99, you must set the “Powered Zone2” set-
ting to “Act” (Activated).
receiver/AV amplifier, as explained in “Connecting Your
Zone 2 Speakers Directly to the AV receiver/AV ampli-
fier” on page 99, you must set the “Powered Zone2” set-
ting to “Act” (Activated).
Notes:
• When “Act” is selected and Zone 2 turned on, the
• When “Act” is selected and Zone 2 turned on, the
Zone 2 speakers connected to the ZONE 2 L/R
speaker terminals output sound, but the surround back
speakers connected to the SURR BACK L/R speaker
terminals do not. When “Act” is selected and Zone 2
turned off, the surround back speakers output sound as
normal.
speaker terminals output sound, but the surround back
speakers connected to the SURR BACK L/R speaker
terminals do not. When “Act” is selected and Zone 2
turned off, the surround back speakers output sound as
normal.
• Powered Zone2 cannot be used if “Speakers Type” is
• This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.
arrow buttons, and [ENTER] button.
Setting the Powered Zone 2
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
lowed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [
q]/[w] but-
tons to select “7. Hardware
Setup”, and then press [ENTER].
The “Hardware Setup” menu appears.
Setup”, and then press [ENTER].
The “Hardware Setup” menu appears.
3
Use the Up and Down [
q]/[w] but-
tons to select “2. Zone2”, and
then press [ENTER].
The “Zone2” menu appears.
then press [ENTER].
The “Zone2” menu appears.
7. Hardware
Setup
1. Remote
Control
2. Zone2
3. Tuner
4. Analog
3. Tuner
4. Analog
Multich
5. HDMI
7–2. Zone2
Powered Zone2
Zone2 Out
Zone2 Out
Not Act
Fixed
4
Use the Up and Down [
q]/[w] but-
tons to select “Powered Zone2”,
and use the Left and Right [
and use the Left and Right [
e]/
[
r] buttons to select:
Not Act:
ZONE 2 L/R speaker terminals not
activated (Powered Zone 2 dis-
abled).
activated (Powered Zone 2 dis-
abled).
Act:
ZONE 2 L/R speaker terminals
activated (Powered Zone 2
enabled).
activated (Powered Zone 2
enabled).
5
Press the [SETUP] button.
The setup menu closes.
The setup menu closes.
TX-SR806_En.book Page 100 Monday, August 4, 2008 10:25 AM