Heartland hcdwis Betriebsanweisung

31

1. If you have not already done so, open dishwasher door and place 
towel over pump assembly and spray arm of dishwasher. This will 
keep screws from falling into pump area when securing dishwasher 
to countertop.
2. Check that dishwasher is still level and centered side to side in the 
opening.
3. Secure dishwasher to countertop or sides of cabinet with two, 
#10 x 1/2” Phillips-head screws. The dishwasher must be secured to 
keep it from tipping when door is opened. Do not drop screws into 
bottom of dishwasher.

4. Open door about 3 inches (7.6 cm) and check that space between 
inner door and tub is equal on both sides. If spacing is not equal, 
loosen bracket screws and shift tub. Tighten bracket screws.
5. If using a countertop attachment to secure dishwasher, check that 
top of door does not contact screws, brackets, or countertop. if it 
does, dishwasher must be lowered and re-leveled.

6. If securing with a side attachment, check that sides of door do 
not rub against the screw heads. If they do, dishwasher must be 
re-centered. When dishwasher is properly centered, replace plastic 
buttons.

7. Remove towel from dishwasher.
8. Reinstall the lower dishrack.

1. Remove the bottom sound pad from inside the dishwasher and 
take it out of the plastic bag.
2. Place pad on the floor in front of the dishwasher, making sure 
lettering is facing up and vinyl pad faces down. 
3. Fold up and hold the side panels down. Carefully slide the pad 
toward the back of the dishwasher as far as it will go, making sure 
not to push or pull any wires or hoses. (Do not force.) Side panels 
will open to proper position.
NOTE: If there are pipes or other obstructions coming up
through the floor, you will need to cut a slit in the pad to fit around 
the obstacle.

4. Fold the front end of the pad up into position. Make sure the 
vinyl pad is tucked up behind the door and the dishwasher front 
legs, as shown.

1. Check that grounding clip is attached to the lower panel.
2. Place the lower panel behind the access panel. Some models have 
insulation on the access panel which must fall behind the insulation 
on the lower panel.
3. Hold the two panels together and push them up against 
dishwasher leg and vinyl pad.
4. Reinstall the screws through the holes in the access panel and the 
slots in the lower panel. Install right side screw first.
5. Check that the lower edge of the lower panel contacts the floor.
6. Tighten the screws.

screw to countertop

screw to

side cabinet

OR

plastic

button