Xerox FreeFlow Accxes Indexer Support & Software Betriebsanweisung
Accxes Copy
Xerox Wide Format FreeFlow Accxes Indexer/FreeFlow Accxes Copy
User Guide
User Guide
3-12
•
While viewing the large black border, check that the image is not skewed and check that all white
areas outside of the border have been cropped.
areas outside of the border have been cropped.
•
If the image does not view as shown in this example or if in any doubt, repeat the scan and ensure
the new scanned image is highlighted when selecting Read Calibration in the Options menu.
the new scanned image is highlighted when selecting Read Calibration in the Options menu.
•
If the calibration sheet you are scanning was printed with nozzles missing, lines, skewed or
unwanted ink marks inside and/or outside the black border perform the following:
unwanted ink marks inside and/or outside the black border perform the following:
•
Ensure the printer is printing correctly and repeat the Print Calibration task
•
Scan in the new printed image
•
Highlight this new image
•
Select Read Calibration from the Options menu to complete a new calibration.
Note
When performing a new 'Read Calibration', it will replace any existing calibration file for the
currently selected print mode.
currently selected print mode.
With the first calibration completed, further print modes can be calibrated or recalibrated as follows:
•
Change the print mode to select one for which you need to perform a calibration or to select a
print mode that you wish to re-calibrate.
print mode that you wish to re-calibrate.
•
From the Accxes Copy UI, select Options > Print Calibration Chart. The calibration chart will print
using the selected print mode.
using the selected print mode.
•
Using the correct scan settings, scan the new calibration print.
•
From the Accxes Copy UI Options menu, select 'Read Calibration Chart'. You will see a status bar
appear as the calibration is performed. The entire process may take approximately one to two
minutes, or more depending upon scan resolution and PC specification.
appear as the calibration is performed. The entire process may take approximately one to two
minutes, or more depending upon scan resolution and PC specification.
•
Repeat the process until all print modes have been printed and calibrated. For the Xerox 7142 this
will include Best, Normal and Draft.
will include Best, Normal and Draft.
•
The system is now ready to be tested as explained in the section in this document entitled,
'Accxes Copy - Test Configuration.”
'Accxes Copy - Test Configuration.”
Note
Color Calibration does not guarantee color accuracy and for some documents the best results may
be obtained by turning off the 'Use Calibration' option. Color accuracy/quality is directly affected
by the media type loaded in the printer, print mode options, scan mode options and Accxes Copy
color options. Experimentation will be required to obtain the best results.
be obtained by turning off the 'Use Calibration' option. Color accuracy/quality is directly affected
by the media type loaded in the printer, print mode options, scan mode options and Accxes Copy
color options. Experimentation will be required to obtain the best results.