Cisco Cisco Prime Infrastructure 2.0 Betriebsanweisung
Cisco Plug and Play Application Solutions Guide
44
• Ensure that the Cisco device is able to ping the Cisco Plug and Play Gateway and IP connectivity
exists between them.
Checking the Status of the Servers
In order to verify that the Cisco Plug and Play Servers are up and running, use the following commands:
Cisco Plug and Play Gateway Server: (If installed separately only)
“PNP {status|start|stop|restart|reload|enable|disable}”
If everything is okay, the command output will indicate “Plug and Play Gateway is running”. In case of
the output will display the issue. In case of issues, restart the Cisco Plug and Play Gateway.
the output will display the issue. In case of issues, restart the Cisco Plug and Play Gateway.
Sample Output:
Plug and Play Gateway is running.
Prime Infra Server:
Use the following command to verify the status of the Cisco Prime Infrastructure server. This will also
include the status of the Cisco Plug and Play Gateway, if they are installed on a single box or are for non-
DMZ deployments.
include the status of the Cisco Plug and Play Gateway, if they are installed on a single box or are for non-
DMZ deployments.
“ncs status”
Sample Output:
Health Monitor Server is running.
Compliance engine is running.
Ftp Server is running
Database server is running
Tftp Server is running
Matlab Server is running
NMS Server is running.
Plug and Play Gateway is running.
SAM Daemon is running ...
DA Daemon is running ...
Syslog Daemon is running ...