Cisco Cisco ONS 15600 SDH Multiservice Provisioning Platform (MSPP) Installationsanleitung

You cannot open an SDH node in the same CTC session where a SONET node is active.

Complete the 

.

Disable all other Ethernet devices (such as a dial-up adapter) on the workstation that runs CTC. For 
instructions, contact the Cisco TAC.

If you have multiple IP addresses on your workstation, you should remove them; you cannot run 
ONS 15600 SDH Software R9.1 if multiple IP addresses are configured. 

If you have multiple ONS 15600 SDH nodes configured in the same IP subnet, ensure that only one is 
connected to a router. Otherwise, the remaining nodes might be unreachable. Refer to the 
Cisco ONS 15600 Reference Manual for LAN-connection suggestions.

Verify that TSC cards are installed in Slots 5 and 10, and that the TSC in Slot 10 is active.

If the TSC in Slot 5 is active, select the slot, and right-click to display a shortcut menu. Click the Soft 
reset Card button. The reset takes a few minutes, and resets the TSC card in Slot 10 as the active TSC.

Complete the 

Ensure that your workstation is one of the following:

IBM-compatible PC with a Pentium III/700 or faster processor, CD-ROM drive, a minimum of 
384 MB RAM and 190 MB of available hard drive space, running Windows 98, Windows NT 4.0 
(with Service Pack 6a), Windows 2000 Professional (with Service Pack 3), or Windows XP 
Professional (with Service Pack 1)

UNIX workstation with Solaris Versions 8 or 9, on an UltraSPARC or faster processor, with a 
minimum of 384 MB RAM and a minimum of 190 MB of available hard drive space

Ensure that your web browser software is one of the following:

Netscape Navigator 7.x or higher on Windows

Internet Explorer 6.x or higher on Windows

Mozilla 1.7 or higher on Solaris

This task verifies that all PC or UNIX workstation hardware and software 
requirements are met.

PC or UNIX workstation

Prerequisite Procedures None

Required

Onsite or remote (but in the presence of the workstation)

Superuser