Cisco Cisco VN 2900 Network Adaptation Interface Installationsanleitung
Installing Cisco Interface Cards in Cisco Access Routers
Installing Cisco Interface Cards on the Cisco ICS 7750
23
01-12842-03
Caution
Always use the extractor levers to disengage or seat cards. Failure to use the levers can cause erroneous
system error messages indicating a card failure.
system error messages indicating a card failure.
Caution
Do not use the extractor levers to lift or support the weight of the cards.
Caution
Devices on system cards can get hot during operation. To remove a card, hold the card by the faceplate
and bottom edge. Allow the card to cool before touching any other part of it or placing it an antistatic
bag.
and bottom edge. Allow the card to cool before touching any other part of it or placing it an antistatic
bag.
Step 7
If you are replacing an interface card, or if there is a blank interface card faceplate already installed in
the MRP or ASI 81 card, use either a number 2 Phillips screwdriver or a small flat-blade screwdriver to
remove the interface card or blank faceplate.
the MRP or ASI 81 card, use either a number 2 Phillips screwdriver or a small flat-blade screwdriver to
remove the interface card or blank faceplate.
Tip
Save the blank faceplate for future use.
Note
If you remove an interface card while the MRP or ASI 81 is running, the interface card configuration is
lost until the system card reboots.
lost until the system card reboots.
Step 8
Align the new interface card with the guides in the ASI 81 or MRP slot, and slide it gently into the slot.
(See
(See