Cisco Cisco VN 2900 Network Adaptation Interface Installationsanleitung

Installing Cisco Interface Cards in Cisco Access Routers

Installing Cisco Interface Cards on the Cisco ICS 7750

01-12842-03

Figure 18

Installing Interface Cards into an MRP Card

Step 9

Push the interface card into place until you feel its edge connector seat securely into the connector on
the MRP or ASI 81.

Step 10

Using a Phillips or flat-blade screwdriver, tighten the interface card mounting screws until the interface
card faceplate makes contact with the faceplate on the MRP or ASI 81 card.

Tip

If an interface card slot on the ASI 81 or MRP is unoccupied, install a filler panel to enable proper
airflow.

Step 11

Align the ASI 81 or MRP with the upper and lower card guides in the chassis slot, and make sure that
the extractor levers are in the open position (pointing outward).

Step 12

With the top and bottom edges of the ASI 81 or MRP in the card guides, gently slide the card into the
chassis until you feel resistance. Because there are grounding clips near the front and rear of the card
guides, you might need to increase the amount of force that you use to get the card past the grounding
clips. If you encounter extreme resistance, pull the card out slightly, and push it back in again.

Step 13

Press the upper and lower extractor levers inward at the same time until they lock into their slots. This
step firmly seats the ASI 81 or MRP into the chassis.

657

STATUS

ALARM

SLOT 0

SHTDN

SLOT 1

Multiservice Route Processor 200

Guides

Interface

card