Cisco Cisco VN 2900 Network Adaptation Interface Installationsanleitung

Connect cables to the ASI 81 or MRP interfaces.

The status LED on the ASI 81 or MRP blinks green as it boots. Wait until the LED is steady green, and 
then verify that the interface card installation. See the 

To verify that an interface card was installed successfully, check the system card LEDs using 

Certain Cisco interface cards support a variety of additional modules, such as small form-factor 
pluggable modules (SFPs).

SFPs are hot-swappable Ethernet interfaces that can be installed directly into Cisco interface cards. The 
following Cisco interface card is currently support SFPs:

HWIC-1GE-SFP

This section describes a generic installation and removal procedure. SFPs use various latch designs (see 

) to secure the module in the SFP port.

Latch designs are not linked to SFP model or technology type; for information on the SFP technology 
type and model, see the label on the side of the SFP.

To install an SFP in a Cisco interface card, perform the following steps:

Install the interface card in the router. (See the 

Status

Shows the status of the MRP or ASI 81:

Blinks green while the card is booting up.

Green after the power-on self-test (POST) is complete, and the card is operating 
correctly.

Slot 0

Shows the slot status of an MRP card that has an interface card installed in the slot, or of 
an 8-port FXS card in the ASI 81:

Green shows that the WIC, VWIC, or VIC is correctly installed in the slot. 

Off indicates that no card is installed in the slot, or that a card is incorrectly installed 
in the slot.

Slot 1