Cisco Cisco Firepower Management Center 4000 Installationsanleitung

This installation guide provides information about deploying, installing, and setting up Cisco NGIPS for 
Blue Coat X-Series. It also assumes familiarity with the features and nomenclature of the X-Series 
platform, the XOS Command Reference Guide, and the XOS Configuration Guide.

See the following sections for more information:

 describes requirements 

you must fulfill to include Cisco NGIPS for Blue Coat X-Series in your FireSIGHT System 
deployment.

 describes the key capabilities of the FireSIGHT 

System.

 describes the 

capabilities of the FireSIGHT System software on the X-Series platform.

 describes the various feature licenses available on the 

FireSIGHT System.

 describes security considerations, 

access requirements, and communication ports for the FireSIGHT System.

 provides information on the content of this guide and outlines the steps for 

installing and configuring Cisco NGIPS for Blue Coat X-Series.

The following sections detail the hardware and other requirements for including Cisco NGIPS for Blue 
Coat X-Series in your FireSIGHT System deployment.

You cannot update Cisco NGIPS for Blue Coat X-Series running Version 4.10.x of the FireSIGHT 
System directly to Version 5.4. Instead, you must uninstall the previous version and reinstall Version 5.4. 
Note that this results in the loss of all configuration and event data on the X-Series installation.

If you want to retain essential configuration and event data, you can perform a limited migration of your 
entire deployment from Version 4.10.3.x (patch 4.10.3.5 or later) to Version 5.2.0.x, then update the 
migrated deployment to Version 5.4. Because Cisco NGIPS for Blue Coat X-Series is not supported with 
Version 5.2, you must update your Defense Center to Version 5.4 before you re-add Cisco NGIPS for 
Blue Coat X-Series. For more information on migration, contact Cisco Support.

Before you install Cisco NGIPS for Blue Coat X-Series on the X-Series platform, you must make sure 
that:

the X-Series platform is installed and configured

the X-Series platform is running XOS version 9.7.2 or later, or version 10.0 or later

each Application Processor Module (APM) where you want to install the software has a minimum 
of 8GB of RAM and a local hard disk

you know the IP address of the default gateway of the management network