Руководство По Установке для Cisco Cisco Firepower Management Center 4000
1-2
Cisco NGIPS for Blue Coat X-Series Installation and Configuration Guide
Chapter 1 Introduction to Cisco NGIPS for Blue Coat X-Series
Prerequisites for Installing Cisco NGIPS for Blue Coat X-Series
This installation guide provides information about deploying, installing, and setting up Cisco NGIPS for
Blue Coat X-Series. It also assumes familiarity with the features and nomenclature of the X-Series
platform, the XOS Command Reference Guide, and the XOS Configuration Guide.
Blue Coat X-Series. It also assumes familiarity with the features and nomenclature of the X-Series
platform, the XOS Command Reference Guide, and the XOS Configuration Guide.
See the following sections for more information:
•
describes requirements
you must fulfill to include Cisco NGIPS for Blue Coat X-Series in your FireSIGHT System
deployment.
deployment.
•
describes the key capabilities of the FireSIGHT
System.
•
describes the
capabilities of the FireSIGHT System software on the X-Series platform.
•
describes the various feature licenses available on the
FireSIGHT System.
•
describes security considerations,
access requirements, and communication ports for the FireSIGHT System.
•
installing and configuring Cisco NGIPS for Blue Coat X-Series.
Prerequisites for Installing Cisco NGIPS for Blue Coat X-Series
The following sections detail the hardware and other requirements for including Cisco NGIPS for Blue
Coat X-Series in your FireSIGHT System deployment.
Coat X-Series in your FireSIGHT System deployment.
You cannot update Cisco NGIPS for Blue Coat X-Series running Version 4.10.x of the FireSIGHT
System directly to Version 5.4. Instead, you must uninstall the previous version and reinstall Version 5.4.
Note that this results in the loss of all configuration and event data on the X-Series installation.
System directly to Version 5.4. Instead, you must uninstall the previous version and reinstall Version 5.4.
Note that this results in the loss of all configuration and event data on the X-Series installation.
Tip
If you want to retain essential configuration and event data, you can perform a limited migration of your
entire deployment from Version 4.10.3.x (patch 4.10.3.5 or later) to Version 5.2.0.x, then update the
migrated deployment to Version 5.4. Because Cisco NGIPS for Blue Coat X-Series is not supported with
Version 5.2, you must update your Defense Center to Version 5.4 before you re-add Cisco NGIPS for
Blue Coat X-Series. For more information on migration, contact Cisco Support.
entire deployment from Version 4.10.3.x (patch 4.10.3.5 or later) to Version 5.2.0.x, then update the
migrated deployment to Version 5.4. Because Cisco NGIPS for Blue Coat X-Series is not supported with
Version 5.2, you must update your Defense Center to Version 5.4 before you re-add Cisco NGIPS for
Blue Coat X-Series. For more information on migration, contact Cisco Support.
Hardware and Operating System Requirements
Before you install Cisco NGIPS for Blue Coat X-Series on the X-Series platform, you must make sure
that:
that:
•
the X-Series platform is installed and configured
•
the X-Series platform is running XOS version 9.7.2 or later, or version 10.0 or later
•
each Application Processor Module (APM) where you want to install the software has a minimum
of 8GB of RAM and a local hard disk
of 8GB of RAM and a local hard disk
•
you know the IP address of the default gateway of the management network