Cisco Cisco Firepower Management Center 4000 Installationsanleitung
3-16
Cisco NGIPS for Blue Coat X-Series Installation and Configuration Guide
Chapter 3 Installing Cisco NGIPS for Blue Coat X-Series
Installing Cisco NGIPS for Blue Coat X-Series
configure dns server server_ip_address vap-group vap_group_name
where
server_ip_address
is the IP address of the DNS server and
vap_group_name
is the name of the
VAP group where you have installed the software. For more information, see the XOS Configuration
Guide.
Guide.
Step 6
When prompted, set a registration key for each VAP in the VAP group.
A registration key is a required alphanumeric value you define. Remember your registration keys; you
must provide them when adding software devices to the Defense Center.
must provide them when adding software devices to the Defense Center.
If you are planning to install Cisco NGIPS for Blue Coat X-Series on multiple VAPs (that is, you have
a VAP group with more than one member, or you are creating more than one VAP group), and you are
registering the software devices to the same Defense Center, the registration key for each VAP must be
unique.
a VAP group with more than one member, or you are creating more than one VAP group), and you are
registering the software devices to the same Defense Center, the registration key for each VAP must be
unique.
Step 7
If a NAT device separates your Cisco NGIPS for Blue Coat X-Series from the Defense Center, follow
the prompt to set a unique NAT ID for each VAP in the VAP group.
the prompt to set a unique NAT ID for each VAP in the VAP group.
Unique NAT IDs are used in a network environment with network address translation (NAT). Remember
your unique NAT IDs; you must provide them when adding software devices to the Defense Center.
your unique NAT IDs; you must provide them when adding software devices to the Defense Center.
If you plan to install Cisco NGIPS for Blue Coat X-Series on multiple VAPs and you are registering the
software devices to the same Defense Center, the NAT ID for each VAP must be unique.
software devices to the same Defense Center, the NAT ID for each VAP must be unique.
Step 8
Press Enter to confirm that you have finished specifying your installation options.
Cisco NGIPS for Blue Coat X-Series is installed.
Step 9
If prompted, reload all VAPs by entering the following command:
CBS# reload vap-group vap_group_name
where
vap_group_name
is the name of the VAP group where you want to install the software.
Tip
The reload prompt appears when you install Cisco NGIPS for Blue Coat X-Series on an existing VAP.
Step 10
Repeat steps 2 through 9 for each VAP group where you are installing Cisco NGIPS for Blue Coat
X-Series.
X-Series.
Verifying the Installation
After you install Cisco NGIPS for Blue Coat X-Series, you can verify that it is installed on each of the
VAPs where you installed it. If application monitoring is enabled (the default) for a VAP Group, the
VAPs where you installed it. If application monitoring is enabled (the default) for a VAP Group, the
show
application
command shows you information about the application. The operational state for a VAP
can be either
up
or
down
. An operational state of
up
indicates that all VAPs in the VAP group are running
and an operational state of
down
indicates that one or more VAPs are not running, or none have been
defined. For more information about application monitoring, see
To verify that Cisco NGIPS for Blue Coat X-Series is running:
Step 1
Show the application information by entering the following command:
show application vap-group vap_group_name
where
vap_group_name
is the name of the VAP group where the software is installed. For example, to
check the state of the application on the VAP group named
ABC
, enter:
show application vap-group
ABC