Cisco Cisco Firepower Management Center 4000 Installationsanleitung
3-17
Cisco NGIPS for Blue Coat X-Series Installation and Configuration Guide
Chapter 3 Installing Cisco NGIPS for Blue Coat X-Series
Uninstalling Cisco NGIPS for Blue Coat X-Series
Step 2
If Cisco NGIPS for Blue Coat X-Series is properly installed the application identity and name are
displayed. For example:
displayed. For example:
VAP Group : ABC
App ID : Sf3DSensor
Name : 3D Sensor
Version : 5.4
Release : 571
Start on Boot : yes
App Monitor : on
Reload on Failure : off
App State (ABC_1) : up
If the application identity and name are not correctly displayed, confirm that your Cisco NGIPS for Blue
Coat X-Series configuration is correct, then uninstall and reinstall Cisco NGIPS for Blue Coat X-Series.
If you continue to have problems, contact Blue Coat support.
Coat X-Series configuration is correct, then uninstall and reinstall Cisco NGIPS for Blue Coat X-Series.
If you continue to have problems, contact Blue Coat support.
Uninstalling Cisco NGIPS for Blue Coat X-Series
If you need to uninstall Cisco NGIPS for Blue Coat X-Series, you can remove it from a VAP group and
from an X-Series platform.
from an X-Series platform.
To uninstall Cisco NGIPS for Blue Coat X-Series:
Step 1
Uninstall the application from a VAP group by entering the following command:
CBS# application Sf3DSensor vap-group vap_group_name uninstall
where
vap_group_name
is the name of the VAP group where the software is installed. For example, to
uninstall the software on a VAP group named
ABC
, enter the following:
CBS# application Sf3DSensor vap-group ABC uninstall
At the prompt, enter
Y
to confirm that you want to uninstall the application, or
N
to cancel the
uninstall
command, and receive the following confirmation:
Command canceled by user
Step 2
Reload all VAPs by entering the following command:
CBS# reload vap-group vap_group_name
For example, to reload all VAPs on the VAP group named
ABC
, enter the following:
CBS# reload vap-group ABC
Step 3
If you have uninstalled Cisco NGIPS for Blue Coat X-Series from all the VAP groups in your X-Series
platform and have no need to install it to other VAP groups in the future, remove the CBI package with
the command:
platform and have no need to install it to other VAP groups in the future, remove the CBI package with
the command:
CBS# application-remove Sf3DSensor
At the prompt, enter
Y
to confirm that you want to remove the application, or
N
to cancel the
remove
command and receive the following confirmation:
Command canceled by user